Home › BODY › EXTERIOR › FENDER LINER (for Rear Side)

FENDER LINER (for Rear Side) > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL HOUSE PAD LH


    B174755
  1. Remove the 3 screws and rear wheel house pad LH.



2. REMOVE REAR WHEEL HOUSE PAD RH

HINT:
Use the same procedure for the RH side and LH side.



3. REMOVE QUARTER PANEL SEAL LH

HINT:
When removing the quarter panel seal, heat the vehicle body and quarter panel seal using a heat light.

Heating temperature:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Quarter Panel Seal
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body or quarter panel seal excessively.



    B174756E01
  1. Remove the 4 screws.

  1. Peel off the double-sided tape and remove the quarter panel seal LH.



4. REMOVE QUARTER PANEL SEAL RH

HINT:
Use the same procedures for the RH side and LH side.



5. REMOVE REAR BUMPER SIDE SEAL LH


    B174757
  1. Remove the clip, screw and bolt.

  1. Remove the 2 grommets.

    HINT:
    The grommets need to be replaced with new ones because they will break when they are removed.

  1. Remove the rear bumper side seal LH.



6. REMOVE REAR BUMPER SIDE SEAL RH

HINT:
Use the same procedures for the RH side and LH side.



7. REMOVE REAR WHEEL HOUSE LINER LH


    B174758
  1. Remove the 10 clips and rear wheel house liner LH.



8. REMOVE REAR WHEEL HOUSE LINER RH


    B174759
  1. Remove the 10 clips and rear wheel house liner RH.