SIDE MUDGUARD > REMOVAL |
| Item | Temperature |
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Side Mudguard | 20 to 30°C (68 to 86°F) |
| 1. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY |
![]() |
Remove the clip.
Using a 4 mm hexagon wrench, remove the screw.
![]() |
Peel off the front fender side protector and disengage the 3 clips, and then remove the front fender moulding sub-assembly.
Remove the pad from the front fender moulding sub-assembly.
Remove the 2 No. 4 clips from the front fender moulding sub-assembly.
![]() |
Remove the front fender side protector from the front fender moulding sub-assembly.
| 2. REMOVE FRONT FENDER OUTSIDE MOULDING PAD |
![]() |
Remove the front fender outside moulding pad from the front fender moulding sub-assembly.
| 3. REMOVE FRONT DOOR OUTSIDE MOULDING SUB-ASSEMBLY |
![]() |
Turn back the front door weatherstrip.
Remove the nut.
![]() |
Peel off the upper front door outside moulding pad and disengage the 11 clips, and then remove the front door outside moulding sub-assembly.
Remove the gasket from the front door outside moulding sub-assembly.
Remove the 3 No. 3 clips from the front door outside moulding sub-assembly.
Remove the 8 No. 4 clips from the front door outside moulding sub-assembly.
![]() |
Remove the upper front door outside moulding pad from the front door outside moulding sub-assembly.
| 4. REMOVE REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY |
![]() |
Turn back the rear door No. 2 weatherstrip.
Remove the nut.
![]() |
Peel off the upper rear door outside moulding pad and disengage the 8 clips, and then remove the rear door outside moulding sub-assembly.
Remove the gasket from the rear door outside moulding sub-assembly.
Remove the 2 No. 3 clips from the rear door outside moulding sub-assembly.
Remove the 6 No. 4 clips from the rear door outside moulding sub-assembly.
![]() |
Remove the upper rear door outside moulding pad from the rear door outside moulding sub-assembly.