Home › BRAKE › BRAKE CONTROL › DOWNHILL ASSIST CONTROL SWITCH (for 4WD)

DOWNHILL ASSIST CONTROL SWITCH (for 4WD) > INSPECTION

for Preparation Click here



1. INSPECT DOWNHILL ASSIST CONTROL SWITCH


    C165841E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 4
    Switch is not pushed in
    10 kΩ or higher
    1 - 4
    Switch is pushed in
    Below 1 Ω

    If the result is not as specified, replace the downhill assist control switch.

  1. Check the illumination operation.

    1. Connect a battery positive (+) lead to terminal 3 and negative (-) lead to terminal 2. Then check that the bulb in the switch illuminates.

      OK:
      Bulb illuminates.

      If the result is not as specified, replace the downhill assist control switch.