Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW RELAY

POWER WINDOW RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT POWER WINDOW RELAY


B060778E79
  1. Remove the power window relay from the instrument panel junction block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Apply battery voltage between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.