Home › ENGINE › 2GR-FE INTAKE › INTAKE MANIFOLD

INTAKE MANIFOLD > INSPECTION

for Preparation Click here



1. INSPECT INTAKE MANIFOLD


    A134934E01
  1. Cylinder head side:

    1. Using a precision straightedge and feeler gauge, measure the surface contacting the cylinder head for warpage.

      Maximum warpage:
      0.1 mm (0.003 in.)
      If the warpage is greater than the maximum, replace the intake manifold.

  1. Surge tank side:

    1. Using a precision straightedge and feeler gauge, measure the surface contacting the surge tank for warpage.

      Maximum warpage:
      0.1 mm (0.003 in.)
      If the warpage is greater than the maximum, replace the intake manifold.