Home › BODY ELECTRICAL › LIGHTING › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR COMBINATION LIGHT BODY GASKET


    E150054
  1. Remove the rear combination light body gasket.

    NOTICE:
    1. Be sure to remove all traces of the old gasket from the body.
    2. Do not reuse the removed gasket. Be sure to install a new rear combination light body gasket to prevent water ingress.



2. REMOVE BACK UP LIGHT BULB


    E150055
  1. Turn the back up light bulb and the back up light socket in the direction indicated by the arrow and remove them as a unit.

  1. Remove the back up light bulb from the back up light socket.



3. REMOVE REAR TURN SIGNAL LIGHT BULB


    E150057
  1. Turn the rear turn signal light bulb and the rear turn signal light socket in the direction indicated by the arrow and remove them as a unit.

  1. Remove the rear turn signal light bulb from the rear turn signal light socket.



4. REMOVE TAIL AND STOP LIGHT BULB


    E150059
  1. Turn the tail and stop light bulb and the tail and stop light socket in the direction indicated by the arrow and remove them as a unit.

  1. Remove the tail and stop light bulb from the tail and stop light socket.



5. REMOVE REAR BUMPER SIDE SUPPORT


    E150061
  1. Disengage the 2 claws and remove the rear bumper side support.