Home › BODY ELECTRICAL › LIGHTING › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > REMOVAL

for Preparation Click here



1. REMOVE STEERING COLUMN COVER


    E151100
  1. Turn the steering wheel assembly to the right and remove the screw as shown in the illustration.



    E151101
  1. Turn the steering wheel assembly to the left and remove the screw as shown in the illustration.



    E151095
  1. Disengage the 2 claws and remove the lower steering column cover.



    E151094
  1. Disengage the claw and remove the upper steering column cover.



2. REMOVE KEY CYLINDER LIGHT ASSEMBLY (w/o Engine Immobiliser System)


    C172130
  1. Using a screwdriver, widen the claws hanging onto the upper bracket by approximately 1.0 mm (0.039 in.).

  1. Pull out the key cylinder light assembly with the claw open.

    NOTICE:
    Using excessive force may damage the case.



3. REMOVE TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System)


    C115569
  1. Using a screwdriver, widen the claws hanging onto the upper bracket by approximately 1.0 mm (0.039 in.).

  1. Pull out the transponder key amplifier with the claw open.

    NOTICE:
    Using excessive force may damage the case.