Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW MASTER SWITCH

POWER WINDOW MASTER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT POWER WINDOW MASTER SWITCH


  1. Check that the switch function.



      B164359E12
    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      8 (U) - 1 (E) - 4 (A)
      Auto UP (Driver side)
      Below 1 Ω
      8 (U) - 1 (E)
      Manual UP (Driver side)
      Below 1 Ω
      5 (D) - 1 (E)
      Manual DOWN (Driver side)
      Below 1 Ω
      4 (A) - 5 (D) - 1 (E)
      Auto DOWN (Driver side)
      Below 1 Ω
      6 (B) - 16 (U)
      15 (D) - 1 (E)
      UP (Passenger side)
      Below 1 Ω
      6 (B) - 15 (D)
      16 (U) - 1 (E)
      DOWN (Passenger side)
      Below 1 Ω
      6 (B) - 12 (U)
      13 (D) - 1 (E)
      UP (Rear LH)
      Below 1 Ω
      6 (B) - 13 (D)
      12 (U) - 1 (E)
      DOWN (Rear LH)
      Below 1 Ω
      6 (B) - 10 (U)
      18 (D) - 1 (E)
      UP (Rear RH)
      Below 1 Ω
      6 (B) - 18 (D)
      10 (U) - 1 (E)
      DOWN (Rear RH)
      Below 1 Ω

      If the result is not as specified, replace the master switch.



  1. Check that the LED illuminates.



      B164359E12
    1. Apply battery voltage to the master switch and check that the LED illuminates.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 3 (LED)
      Battery negative (-) → Terminal 1 (E)
      LED illuminates

      If the result is not as specified, replace the master switch.