Home › SECURITIES › THEFT DETERRENT › SECURITY INDICATOR LIGHT ASSEMBLY

SECURITY INDICATOR LIGHT ASSEMBLY > INSPECTION



1. INSPECT SECURITY INDICATOR LIGHT


    B154244E11
  1. Disconnect the D40 ECU connector, with the E19 indicator connector connected.

  1. Apply battery voltage from the wire harness back side between the terminals of the indicator, and check the lighting condition of the security indicator.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal E19-2 (IND+)
    Battery negative (-) → Terminal E19-5 (E)
    Security indicator comes on

    NOTICE:
    1. If the positive (+) lead and the negative (-) lead are incorrectly connected, the security indicator will not come on.
    2. Voltage of more than 12 V will damage the security indicator.
    3. If the voltage is too low, the security indicator will not come on.

    If the result is not as specified, replace the passenger belt and airbag indicator.