Home › BODY ELECTRICAL › AUDIO / VISUAL › RADIO ANTENNA CORD (for Satellite Radio)

RADIO ANTENNA CORD (for Satellite Radio) > INSTALLATION

for Preparation Click here



1. INSTALL SATELLITE RADIO ANTENNA ASSEMBLY


    E173851
  1. Engage the 2 claws to install the satellite radio antenna assembly.



    E173850E01
  1. Place the antenna cord in the cutout of the antenna nut.

  1. Install the satellite radio antenna assembly with the antenna nut.

    Torque:
    4.5 N*m{ 45 kgf*cm , 40 in.*lbf }



    E173849
  1. Install the antenna wire to the 3 clamps.



2. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY (for Glass Antenna Type)

HINT:
The double-sided tape and tape are not available as supply parts. If they still have enough adhesion to secure the roof headlining and antenna cord, reuse them. If the roof headlining has been replaced with a new one, or if the tape and/or the double-sided tape is no longer sticky, apply new tape following the procedures below.



  1. Apply new double-sided tape.


    E150570E02


    1. Remove the double-sided tape from the roof headlining assembly.

    2. Peel off the appropriate amount of new double-sided tape.

      HINT:
      Be careful not to touch the adhesive surface.

      Area
      Dimension
      A
      1.0 mm (0.0394 in.)
      B
      15.0 mm (0.591 in.)

    3. Apply the double-sided tape to the roof headlining while aligning the tape with the markings on the roof headlining assembly.

    4. Peel off the backing sheet from the double-sided tape.



  1. Install the antenna cord to the roof headlining assembly from the front of the vehicle.


    E171647E01

    NOTICE:
    1. Install the antenna cord with the red circle facing up.
    2. Make sure that the antenna cord is not twisted.

    HINT:
    For the right front corner of the roof headlining assembly, align the marking tape on the antenna cord with the protrusion of the roof headlining, and wrap tape around the antenna cord and roof headlining assembly once or twice to securely hold them.



3. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY (for Pole Antenna Type)

HINT:
The double-sided tape and tape are not available as supply parts. If they still have enough adhesion to secure the roof headlining and antenna cord, reuse them. If the roof headlining has been replaced with a new one, or if the tape and/or the double-sided tape is no longer sticky, apply new tape following the procedures below.



  1. Apply new double-sided tape.


    E150570E02


    1. Remove the double-sided tape from the roof headlining assembly.

    2. Peel off the appropriate amount of new double-sided tape.

      HINT:
      Be careful not to touch the adhesive surface.

      Area
      Dimension
      A
      1.0 mm (0.0394 in.)
      B
      15.0 mm (0.591 in.)

    3. Apply the double-sided tape to the roof headlining while aligning the tape with the markings on the roof headlining assembly.

    4. Peel off the backing sheet from the double-sided tape.



  1. Install the antenna cord to the roof headlining assembly from the front of the vehicle.


    E150569E01

    HINT:
    For the right front corner of the roof headlining assembly, align the marking tape on the antenna cord with the protrusion of the roof headlining, and wrap tape around the antenna cord and roof headlining assembly once or twice to securely hold them.



4. INSTALL ROOF HEADLINING ASSEMBLY
Refer to the procedure from Install Roof Headlining Assembly (Click here).