Home › BODY ELECTRICAL › AUDIO / VISUAL › RADIO ANTENNA CORD (for Satellite Radio)

RADIO ANTENNA CORD (for Satellite Radio) > REMOVAL

for Preparation Click here



1. REMOVE ROOF HEADLINING ASSEMBLY
Refer to the procedure up to Remove Roof Headlining Assembly (Click here).


2. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY


  1. Peel off the pieces of tape used to secure the antenna cord only enough to allow removal of the antenna cord.


    E150569E01

    HINT:
    Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining so that the tape can be reused.

  1. Remove the No. 2 antenna cord sub-assembly from the roof headlining.



3. REMOVE SATELLITE RADIO ANTENNA ASSEMBLY


    E173849
  1. Remove the antenna wire from the 3 clamps.



    E173850
  1. Remove the antenna nut.



    E173851
  1. Disengage the 2 claws and remove the satellite radio antenna assembly.