Home › BODY › WINDSHIELD / WINDOWGLASS › BACK WINDOW LOCK

BACK WINDOW LOCK > INSPECTION

for Preparation Click here



1. INSPECT BACK WINDOW LOCK ASSEMBLY


    B172579E01
  1. Check operation of the back window lock assembly.

    1. Move the back window lock assembly to the lock position.

    2. Apply the battery voltage to the window lock motor and check the operation of the window lock motor.
      OK: 
      Measurement Condition
      Specified Condition
      Battery positive (+) → 3
      Battery negative (-) → 4
      Unlock
      If the result is not as specified, replace the back window lock assembly.



    B172579E01
  1. Check operation of the back window courtesy switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Lock
      10 kΩ or higher
      1 - 2
      Unlock
      Below 1 Ω

      If the result is not as specified, replace the back window lock assembly.