WASHER LEVEL WARNING SWITCH > INSPECTION |
| 1. INSPECT LEVEL WARNING SWITCH ASSEMBLY |
![]() |
Remove the washer jar.
Disconnect the level warning switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (SLR1) - 2 (E) | Washer jar is full | 10 kΩ or higher |
| 1 (SLR1) - 2 (E) | Washer jar is empty | Below 1 Ω |