CLOCK (w/ Multi-information Display) > INSTALLATION |
| 1. INSTALL MULTI INFORMATION DISPLAY CLOCK ASSEMBLY |
| 2. INSTALL NO. 2 RADIO BRACKET (w/o Navigation System) |
![]() |
Install the No. 2 radio bracket with the 5 screws.
| 3. INSTALL NO. 2 RADIO RECEIVER BRACKET (w/ Navigation System) |
![]() |
Install the No. 2 radio receiver bracket with the 6 screws.
| 4. INSTALL NO. 1 RADIO BRACKET (w/o Navigation System) |
![]() |
Install the No. 1 radio bracket with the 5 screws.
![]() |
Engage the claw and install the connector.
| 5. INSTALL NO. 1 RADIO RECEIVER BRACKET (w/ Navigation System) |
![]() |
Install the No. 1 radio receiver bracket with the 6 screws.
![]() |
Engage the claw and connect the connector.
| 6. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System) |
Connect each connector.
![]() |
Engage the 4 clips.
![]() |
Install the radio receiver assembly with bracket with the 4 bolts.
| 7. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System) |
Connect each connector.
![]() |
Engage the 4 clips.
![]() |
Install the navigation receiver assembly with bracket with the 4 bolts.
| 8. INSTALL HEATER CONTROL AND ACCESSORY ASSEMBLY (for Manual Air Conditioning System) |
Connect the connector.
![]() |
Engage the 4 clips and install the heater control and accessory assembly.
| 9. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System) |
Connect the connector.
![]() |
Engage the 4 clips and install the air conditioning control assembly.
| 10. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/o Smart Key System) |
![]() |
Apply protective tape to the areas shown in the illustration.
Connect each connector.
Engage the 10 claws and 8 clips, and install the center instrument cluster finish panel assembly.
| 11. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/ Smart Key System) |
![]() |
Apply protective tape to the areas shown in the illustration.
Connect each connector.
Engage the 10 claws and 8 clips, and install the center instrument cluster finish panel assembly.
| 12. INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY |
![]() |
Engage the 2 claws and 5 clips, and install the center instrument panel register assembly.