Home › ENGINE › 2GR-FE EMISSION CONTROL › PURGE VALVE

PURGE VALVE > INSPECTION

for Preparation Click here



1. INSPECT PURGE VSV


  1. Check the VSV for an open circuit.



      A128939E03
    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 - 2
      23 to 26 Ω at 20°C (68°F)
      1 - Body ground
      2 - Body ground
      10 MΩ or higher

      If the result is not as specified, replace the VSV.



  1. Check operation of the VSV.



      A128937E01
    1. Check that air does not flow from the F port as shown in the illustration.
      If the result is not as specified, replace the VSV.



    2. A128938E01
    3. Apply battery positive voltage across the terminals.

    4. Check that air flows from the F port as shown in the illustration.
      If the result is not as specified, replace the VSV.