Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › ACTIVE CONTROL ENGINE MOUNT

ACTIVE CONTROL ENGINE MOUNT > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FRONT ENGINE MOUNTING INSULATOR ASSEMBLY
  1. Inspect the front engine mounting insulator assembly.

    1. Connect Techstream to DLC3.

    2. Start the engine and turn the Techstream main switch on.

    3. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the ACM Inhibit.

      Tester Display
      Test Part
      Control Range
      Diagnostic Note
      Control the ACM Inhibit
      ACM
      ON / OFF
      Test is possible while engine is idling

    4. Check if the front engine mounting insulator assembly operates in accordance with tester operation.

      Standard:
      The front engine mounting insulator assembly operates normally in accordance with tester operation.