Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM (w/o Smart Key System)

THEFT DETERRENT SYSTEM (w/o Smart Key System) > Security Horn Circuit


DESCRIPTION

When the theft deterrent system is switched from the armed state to the alarm sounding state, the main body ECU controls the security horn.

WIRING DIAGRAM


B154245E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ENGINE ROOM JUNCTION BLOCK)


    B177821E01
  1. Disconnect the D10 ECU connector.

  1. Connect a negative battery lead to terminal 6 (SH) of the D10 ECU connector.

  1. Check operation of the security horn.

    OK:
    Measurement Condition
    Specified Condition
    Battery negative (-) → D10-6 (SH)
    Horn sounds



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT SECURITY HORN ASSEMBLY


    B139440
  1. Remove the security horn assembly (Click here).

  1. Check operation of the horn.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Horn sounds
    Battery negative (-) → Horn body



NG
REPLACE SECURITY HORN ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (ENGINE ROOM JUNCTION BLOCK ASSEMBLY - SECURITY HORN ASSEMBLY)


    B154256E01
  1. Disconnect the 2A engine room junction block assembly connector and A15 security horn assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    2A-5 - A15-1
    Always
    Below 1 Ω
    2A-5 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (BATTERY - ENGINE ROOM JUNCTION BLOCK ASSEMBLY)


    B178145E01
  1. Disconnect the 2G engine room junction block assembly connector.

  1. Measure the voltage on the relay block side according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    2G-1 - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK HARNESS AND CONNECTOR (ENGINE ROOM JUNCTION BLOCK ASSEMBLY - MAIN BODY ECU)
  1. Disconnect the 2D engine room junction block assembly connector.

  1. Disconnect the D10 ECU connector.



  1. Measure the resistance according to the value(s) in the table below.


    B154255E01

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    2D-11 - D10-6 (SH)
    Always
    Below 1 Ω
    D10-6 (SH) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ENGINE ROOM JUNCTION BLOCK ASSEMBLY