Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › VACUUM SWITCHING VALVE (for Engine Mounting)

VACUUM SWITCHING VALVE (for Engine Mounting) > INSPECTION

for Preparation Click here



1. INSPECT DUTY VACUUM SWITCHING VALVE (OPERATION)


    A052014E04
  1. Check the operation of the duty vacuum switching valve when positive battery voltage is applied to its terminals.

    Positive battery voltage is not applied:
    The air from pipe G is flowing out through pipes E and H.

    Positive battery voltage is applied:
    The air from pipe F is flowing out through pipes E and H.



2. INSPECT DUTY VACUUM SWITCHING VALVE (RESISTANCE)


    A172495E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    19 to 21 Ω

    If the resistance is not as specified, replace the duty vacuum switching valve.