Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › VACUUM SWITCHING VALVE (for Engine Mounting)

VACUUM SWITCHING VALVE (for Engine Mounting) > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER ASSEMBLY


    A171849
  1. Remove the 2 bolts and engine under cover assembly RR.



    A171850
  1. Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.



2. REMOVE NO. 1 ENGINE UNDER COVER


    A171855
  1. Remove the 6 bolts, 2 clips and No. 1 engine under cover.



3. REMOVE VACUUM HOSE SUB-ASSEMBLY


    A171739
  1. Disconnect the vacuum hose sub-assembly from the air cleaner cap sub-assembly and vacuum switching valve.



    A171740
  1. Remove the 2 clamps.



    A171741
  1. Disconnect the vacuum hose sub-assembly from the duty vacuum switching valve and remove it.



4. REMOVE DUTY VACUUM SWITCHING VALVE


    A172494
  1. Disconnect the duty vacuum switching valve connector and the clamp.



    A172486
  1. Remove the bolt.



    A172487
  1. Disconnect the hose from the duty vacuum switching valve and remove the duty vacuum switching valve.