Home › BODY ELECTRICAL › OTHER SYSTEM › VOLTAGE INVERTER

VOLTAGE INVERTER > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT VOLTAGE INVERTER ASSEMBLY

HINT:
Remove interior parts so that the voltage inverter can be seen.



    E153101E02
  1. Disconnect the voltage inverter connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:

    Tester connection
    Condition
    Specified condition
    O20-1 (IG) - O20-4 (GND)
    Ignition switch on (IG)
    10 to 16 V
    O20-4 (GND) - Body ground
    Always
    Below 1 V

    If the result is not as specified, repair or replace the harness or connector.



    E153102E02
  1. Reconnect the voltage inverter connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:

    Tester connection
    Condition
    Specified condition
    O20-3 (AC1) - O20-7 (AC2)
    Ignition switch on (IG)
    Main switch ON
    Approximately AC 115 V

    If the result is not as specified, replace the voltage inverter.