POWER BACK DOOR SYSTEM > Power Back Door cannot be Closed Using the Power Back Door Closer Switch |

| 1.READ VALUE ON TECHSTREAM |
Check the Data List to determine if the power back door closer switch functions properly.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| PBD Close SW | Power back door closer switch signal / ON or OFF | ON: Power back door closer switch ON OFF: Power back door closer switch OFF | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT POWER BACK DOOR CLOSER SWITCH |
![]() |
Remove the power back door closer switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
| 1 - 2 | Pushed (ON) | Below 1 Ω |
| 1 - 2 | Free (OFF) | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (POWER BACK DOOR CLOSER SWITCH - POWER BACK DOOR DRIVE UNIT) |
![]() |
Disconnect the T10 switch connector.
Disconnect the O15 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T10-1 - O15-4 (DS1) | Always | Below 1 Ω |
| T10-2 - Body ground | Always | Below 1 Ω |
| T10-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||