Home › BODY › ENGINE HOOD / DOOR › POWER BACK DOOR SYSTEM

POWER BACK DOOR SYSTEM > Power Back Door Warning System does not Operate

for Preparation Click here


DESCRIPTION

When the power back door warning system does not operate, one of the following may be malfunctioning: 1) power back door warning buzzer circuit, 2) wireless door lock control system, or 3) power back door drive unit (power back door ECU).

WIRING DIAGRAM


B165222E05


INSPECTION PROCEDURE

1.CHECK OPERATION
  1. Check the power back door system operation.

    Result:
    Result
    Proceed to
    Power back door warning buzzer does not operate.
    A
    Hazard warning light does not come on.
    B
    Power back door warning buzzer in the power back door ECU does not operate.
    C



B
Go to step 5

C
REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU) (Click here)
A


2.PERFORM ACTIVE TEST ON TECHSTREAM
  1. Select the Active Test, use Techstream to generate a control command, and check that the power back door buzzer sounds.

    Back door (Power back door ECU) 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    PBD Buzzer
    Power back door buzzer sound
    ON / OFF
    -

    OK:
    Buzzer sounds normally.



NG
Go to step 3
OK

REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU) (Click here)  

3.INSPECT POWER BACK DOOR WARNING BUZZER


    B177974E01
  1. Remove the power back door warning buzzer. (Click here)

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Always
    950 to 1050 Ω



NG
REPLACE POWER BACK DOOR WARNING BUZZER (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (POWER BACK DOOR WARNING BUZZER - POWER BACK DOOR ECU)


    B165206E02
  1. Disconnect the T9 buzzer connector.

  1. Disconnect the O15 ECU connector.

  1. Disconnect the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    T9-1 - O15-26 (BZR+)
    Always
    Below 1 Ω
    T9-2 - Body ground
    Always
    Below 1 Ω
    T9-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU) (Click here)  

5.CHECK WIRELESS DOOR LOCK CONTROL SYSTEM (HAZARD ANSWER-BACK FUNCTION)
  1. Check the wireless door lock operation.

    OK:
    Hazard answer-back function operates normally.



NG
GO TO OTHER FLOW CHART (Click here)
OK


6.REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU)
  1. Replace the power back door drive unit (power back door ECU) (Click here).


NEXT


7.CHECK POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU)
  1. Check that the power back door warning buzzer operates normally.

    OK:
    It operates normally.



NG
REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)
OK

END (REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU) DEFECTIVE)