Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › FUEL PUMP RELAY

FUEL PUMP RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FUEL PUMP RELAY


    A137690
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    No battery voltage applied
    Below 1 Ω
    3 - 5
    No battery voltage applied
    10 kΩ or higher
    3 - 4
    Battery voltage applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.