Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › IGNITION RELAY NO. 2

IGNITION RELAY NO. 2 > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT NO. 2 IGNITION RELAY


    B016200
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    No battery voltage applied
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.