Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › ACTIVE CONTROL ENGINE MOUNT

ACTIVE CONTROL ENGINE MOUNT > INSPECTION

for Preparation Click here



1. INSPECT FRONT ENGINE MOUNTING INSULATOR ASSEMBLY
  1. Disconnect the vacuum hose from the front engine mounting insulator assembly.



    A171736
  1. Using a vacuum pump, apply vacuum of 80 kPa (600 mmHg, 25 in.Hg) and wait for 1 minute.

  1. Check that there is no change in the needle movement of the vacuum pump gauge.

    OK:
    Vacuum pressure holds.

  1. Check that there is no fluid leakage caused by a break in the diaphragm.

  1. Reconnect the vacuum hose.