Home › SERVICE SPECIFICATIONS › SERVICE SPECIFICATIONS › BRAKE CONTROL

BRAKE CONTROL > SERVICE DATA



STOP LIGHT CONTROL RELAY 
Tester Connection
Switch Condition
Specified Condition
3 - 4
Voltage is not applied between terminals 1 and 2
Below 1 Ω
3 - 5
Voltage is not applied between terminals 1 and 2
10 kΩ or higher
3 - 4
Voltage is applied between terminals 1 and 2
Below 1 Ω
3 - 5
Voltage is applied between terminals 1 and 2
10 kΩ or higher

VSC OFF SWITCH 
Tester Connection
Switch Condition
Specified Condition
3 - 6
Switch is not pushed in
10 kΩ or higher
3 - 6
Switch is pushed in
Below 25Ω
4 - 5
Battery's positive (+) lead connected to terminal 5 and negative (-) lead to terminal 4
LED illuminates

BRAKE PEDAL LOAD SENSING SWITCH 
Tester Connection
Switch Condition
Specified Condition
2 (FSW+) - 1(GND)
Brake pedal load sensing switch OFF (Brake pedal depressed)
950 to 1050 Ω
2 (FSW+) - 1(GND)
Brake pedal load sensing switch ON (Brake pedal released)
203 to 223 Ω

DOWNHILL ASSIST CONTROL SWITCH 
Tester Connection
Switch Condition
Specified Condition
1 - 4
Switch is not pushed in
10 kΩ or higher
1 - 4
Switch is pushed in
Below 1 Ω