Home › BRAKE › BRAKE › REAR BRAKE

REAR BRAKE > REMOVAL

for Preparation Click here


NOTICE:
While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore, during servicing of the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.



1. REMOVE REAR WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
If brake fluid leaks onto any painted surface, wash off and remove it completely.



3. DISCONNECT REAR FLEXIBLE HOSE


    C167068
  1. Remove the union bolt and gasket, and disconnect the rear flexible hose from the rear disc brake cylinder assembly.



4. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY


    C166430E01
  1. Hold the 2 rear disc brake cylinder slide pins, and remove the 2 bolts and rear disc brake cylinder assembly.