SFI SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC (Using the Techstream) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menu items: Powertrain / Engine and ECT / Trouble Codes.
Check the DTC(s) and freeze frame data, and then write them down.
Check the details of the DTC(s) (Click here).
| CLEAR DTC (Using the Techstream) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menu items: Powertrain / Engine and ECT / Trouble Codes.
Erase the DTCs.
| CLEAR DTC (Without using the Techstream) |
Perform either one of the following operations:
Disconnect the negative battery cable for more than 1 minute.
Remove the IGCT No. 5 and ETCS fuses from the fusible link block and R/B No. 4 located inside the engine compartment for more than 1 minute.