SFI SYSTEM > CHECK MODE PROCEDURE |
| CHECK MODE PROCEDURE |
Check and ensure the following conditions:
Battery positive voltage 11 V or more.
Transmission in the P position.
A/C switched OFF.
Turn the power switch off.
Connect the Techstream to the DLC3.
Turn the power switch on (READY).
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode.
Switch the ECM (included in the hybrid vehicle control ECU) from normal mode to check mode.
![]() |
Make sure that the MIL flashes as shown in the illustration.
Turn the power switch on (READY).
Make sure that the MIL turns OFF.
Simulate the conditions of the malfunction described by the customer.
Check the DTCs and freeze frame data using the Techstream.