Home › ENGINE › 3MZ-FE ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > BASIC INSPECTION

for Preparation Click here


When the malfunction is not confirmed by the DTC check, troubleshooting should be carried out in all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following flowchart, the location of the problem can be found quickly and efficiently. Therefore, using this check is essential when troubleshooting the engine.


1.CHECK BATTERY VOLTAGE

    NOTICE:
    Carry out this check with the engine stopped and the power switch off.


    Result:

    Result
    Proceed to
    11 V or more
    OK
    Below 11 V
    NG



NG.
CHARGE OR REPLACE BATTERY
OK


2.CHECK WHETHER ENGINE CRANKS


    NG.
    PROCEED TO PROBLEM SYMPTOMS TABLE
    OK


    3.CHECK WHETHER ENGINE STARTS


      NG.
      GO TO STEP 6
      OK


      4.CHECK AIR FILTER
      1. Visually check that the air filter is not excessively contaminated with dirt or oil.



      NG.
      REPLACE AIR FILTER
      OK


      5.CHECK IDLE SPEED


        NG.
        PROCEED TO PROBLEM SYMPTOMS TABLE
        OK


        6.CHECK FUEL PRESSURE


          NG.
          CHECK FUEL SYSTEM
          OK


          7.CHECK FOR SPARK


            NG.
            CHECK IGNITION SYSTEM
            OK

            PROCEED TO PROBLEM SYMPTOMS TABLE