DTC
| Component
| Fail-Safe Operation
| Fail Safe Deactivation Condition
|
P0031, P0032, P0051 and P0052
| Air Fuel Ratio Sensor Heater
| ECM turns off air fuel ratio sensor heater
| Power switch off
|
P0037, P0038, P0057 and P0058
| Heated Oxygen Sensor (HO2S) Heater
| ECM turns off heated oxygen sensor heater
| Power switch off
|
P0087, P0088
| High Pressure Side Fuel Pump
| - ECM stops the high pressure side fuel pump
- ECM limits the engine speed to 2000 rpm or less
| Pass condition detected
|
P0100, P0102 and P0103
| Mass Air Flow Meter
| ECM calculates ignition timing according to engine speed and throttle valve position
| Pass condition detected
|
P0110, P0112 and P0113
| Intake Air Temperature Sensor
| ECM estimates intake air temperature to be 20°C (68°F)
| Pass condition detected
|
P0115, P0117 and P0118
| Engine Coolant Temperature Sensor
| ECM estimates engine coolant temperature to be 80°C (176°F)
| Pass condition detected
|
P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P0607, P0657, P2102, P2103, P2111, P2112, P2118, P2119 and P2135
| Electronic Throttle Control System
| ECM cuts off throttle actuator current and throttle valve returns to 6° throttle position by return spring. ECM then adjusts engine output by controlling fuel injection (intermittent fuel-cut) and ignition timing in accordance with accelerator pedal opening angle to allow vehicle to continue at minimal speed*1.
| Pass condition detected and then power switch turned off
|
P0327, P0328, P0332 and P0333
| Knock Sensor
| ECM sets ignition timing to maximum retard.
| Power switch off
|
P0351 to P0356
| Igniter
| ECM cuts fuel
| Pass condition detected
|