DTC P0121 Throttle / Pedal Position Sensor / Switch "A" Circuit Range / Performance Problem |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0121 | Difference between VTA and VTA2 voltages less than 0.8 V or more than 1.6 V for 2 seconds (1 trip detection logic) | Throttle position sensor (built into throttle body) |
| Related DTCs | P0121: TP sensor rationality |
| Required Sensors/Components (Main) | Throttle position sensor |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | Within 2 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs are not present | None |
| Either of following conditions A or B is met | - |
| A. Power switch | ON |
| B. Electric throttle motor power | ON |
| Throttle position sensor malfunction (P0120, P0122, P0123, P0220, P0222, P0223, P2135) | Not detected |
| Difference in voltage between VAT1 and VTA2 Throttle position sensor 1 - [Throttle position sensor 2 x 0.8 (corrected by learning value)] | Less than 0.8 V or more than 1.6 V |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0121) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Display (DTC output) | Proceed to |
| P0121 | A |
| P0121 and other DTCs | B |
|
| ||||
| A | ||
| ||