DTC P2102 Throttle Actuator Control Motor Circuit Low |
DTC P2103 Throttle Actuator Control Motor Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2102 |
|
|
| P2103 | Hybrid IC diagnosis signal failure (0.6 seconds) (1 trip detection logic) |
|
| Related DTCs | P2102: Throttle actuator current (low current) P2103: Throttle actuator current (high current) |
| Required Sensors/Components (Main) | Throttle actuator (throttle body) |
| Required Sensors/Components (Related) | None |
| Frequency of Operation | Continuous |
| Duration | P2102: 2 seconds P2103: 25 times |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs are not present | None |
| Throttle motor | ON |
| Duty-cycle ratio to open throttle actuator | 80% or more |
| Throttle actuator power supply | 8 V or more |
| Current motor current - Motor current at 0.016 sec. before | Less than 0.2 A |
| Throttle motor | ON |
| Either of the following conditions 1 or 2 is met: | - |
| 1. Throttle actuator power supply | 8 V or more |
| 2. Throttle actuator power | ON |
| Battery voltage | 8 V or more |
| Throttle actuator current | Less than 0.5 A |
| Hybrid IC diagnosis signal | Fail |

| 1.INSPECT THROTTLE BODY ASSEMBLY (RESISTANCE OF THROTTLE CONTROL MOTOR) |
![]() |
Disconnect the throttle body connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B27-2 (M+) - B27-1 (M-) | Always | 0.3 to 100 Ω at 20°C (68°F) |
Reconnect the throttle body connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (THROTTLE CONTROL MOTOR - HYBRID VEHICLE CONTROL ECU) |
![]() |
Disconnect the throttle body connector.
Disconnect the hybrid vehicle control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B27-2 (M+) - B3-3 (M+) | Always | Below 1 Ω |
| B27-1 (M-) - B3-2 (M-) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| B27-2 (M+) or B3-3 (M+) - Body ground | Always | 10 kΩ or higher |
| B27-1 (M-) or B3-2 (M-) - Body ground | Always | 10 kΩ or higher |
Reconnect the throttle body connector.
Reconnect the hybrid vehicle control ECU connector.
|
| ||||
| OK | |
| 3.INSPECT THROTTLE BODY ASSEMBLY |
Check for foreign objects or carbon between the throttle valve and the housing.
|
| ||||
| OK | |
| 4.INSPECT THROTTLE VALVE |
Check if the throttle valve opens and closes smoothly.
|
| ||||
| OK | ||
| ||