Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > Cruise Main Indicator Light Circuit

for Preparation Click here


DESCRIPTION

  1. The hybrid vehicle control ECU detects a cruise control switch signal and sends it to the combination meter through CAN. Then the CRUISE main indicator light comes on.
  2. The CRUISE main indicator light circuit uses CAN for communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.

INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. Check the CRUISE main indicator light by performing the Active Test.

    Combination Meter: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Lamp Cruise
    CRUISE main indicator light
    Indicator light BLINK / OFF
    -

    OK:
    The indicator light blinks/goes off.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


2.READ VALUE USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Enter the following menus: Powertrain / Cruise Control / Data List.

  1. Check the Data List for proper functioning of the CRUISE main indicator light.

    Hybrid Vehicle Control ECU (Cruise Control): 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    CCS Indicator M-CPU
    Cruise indicator signal (Main CPU) / ON or OFF
    ON: "CRUISE" on
    OFF: "CRUISE" off
    -

    OK:
    When the cruise control main switch is operated, the display changes as shown above.



NG
REPLACE HYBRID VEHICLE CONTROL ECU (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)