Home › HYBRID SYSTEM ยท P310 › HYBRID TRANSMISSION / TRANSAXLE › SHIFT LEVER POSITION SENSOR

SHIFT LEVER POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 6 bolts, 2 screws, 2 clips and No. 1 engine under cover.



2. DRAIN HYBRID TRANSAXLE FLUID


    C173143E01
  1. Using a socket hexagon wrench 10 mm, remove the filler plug and gasket.

  1. Using a socket hexagon wrench 10 mm, remove the drain plug and gasket.

  1. Using a socket hexagon wrench 10 mm, install the drain plug, and a new gasket.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }



3. SEPARATE OIL COOLER TUBE SUB-ASSEMBLY


    C113018
  1. Separate the 2 oil cooler hoses from the oil cooler tubes.

  1. Remove the bolt and oil cooler tube with bracket.



    C113019
  1. Using a union nut wrench 17 mm and a wrench, separate the oil cooler tubes.



    C172977
  1. Remove the bolt and clamp, and separate the 2 oil cooler tubes.



4. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY


    C108745
  1. Remove the nut from the control shaft lever.



    C175424E01
  1. Using a screwdriver, disengage the 2 claws, and disconnect the control cable with clip from the control cable bracket.

    HINT:
    Tape up the screwdriver tip before use.

  1. Remove the clip.



5. REMOVE SHIFT LEVER POSITION SENSOR


    C108747
  1. Disconnect the shift lever position sensor connector.



    C108748E02
  1. Remove the nut, washer and control shaft lever.



    C108749E01
  1. Using a screwdriver, pry out the lock plate.



    C110903E02
  1. Remove the lock nut and lock plate.



    C108750
  1. Remove the 2 bolts and pull out the shift lever position sensor.