REAR DRIVE SHAFT > REMOVAL |
| 1. REMOVE REAR WHEEL |
| 2. SEPARATE REAR SPEED SENSOR LH |
![]() |
Remove the bolt and separate the rear speed sensor from the rear axle carrier sub-assembly.
| 3. REMOVE REAR AXLE SHAFT NUT LH |
![]() |
Using SST and a hammer, release the staked part of the rear axle shaft nut.
While applying the brakes, remove the rear axle shaft nut.
| 4. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH |
![]() |
Remove the 2 bolts and separate the rear disc brake caliper assembly.
| 5. REMOVE REAR DISC |
![]() |
Put matchmarks on the rear disc and the axle hub.
![]() |
Release the parking brake and remove the rear disc.
| 6. SEPARATE REAR AXLE HUB AND BEARING ASSEMBLY LH |
![]() |
Put matchmarks on the rear drive shaft and rear axle hub.
![]() |
Remove the 4 bolts and the rear axle hub and bearing assembly.
| 7. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY |
![]() |
Remove the nut and separate the No. 3 parking brake cable assembly.
| 8. REMOVE REAR STRUT ROD ASSEMBLY |
![]() |
Remove the 2 bolts, the 2 nuts, and the rear strut rod assembly.
| 9. SEPARATE REAR AXLE CARRIER SUB-ASSEMBLY LH |
![]() |
Loosen the 2 bolts.
![]() |
Remove the 2 bolts and 2 nuts, and separate the rear shock absorber with coil spring (lower side) from the rear axle carrier sub-assembly.
![]() |
Remove the 2 bolts, the 2 nuts, and the rear axle carrier sub-assembly.
| 10. REMOVE REAR DRIVE SHAFT ASSEMBLY |
![]() |
Put matchmarks on the rear drive shaft assembly and differential side gear shaft.
Remove the 4 nuts, washers and rear drive shaft assembly.