Home › DRIVE LINE › DRIVE SHAFT › REAR DRIVE SHAFT

REAR DRIVE SHAFT > DISASSEMBLY

for Preparation Click here



1. REMOVE NO. 2 REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP


  1. for One touch type:



      C108296
    1. Using a screwdriver, remove the No. 2 rear drive shaft inboard joint boot clamp as shown in the illustration.



  1. for Claw engagement type:



      C171766E01
    1. Using needle nose pliers, remove the No. 2 rear drive shaft inboard joint boot clamp as shown in the illustration.



2. REMOVE REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP


  1. for One touch type:



      C108298
    1. Using a screwdriver, remove the rear drive shaft inboard joint boot clamp as shown in the illustration.



  1. for Claw engagement type:



      C171767E01
    1. Using needle nose pliers, remove the rear drive shaft inboard joint boot clamp as shown in the illustration.



3. SEPARATE INBOARD JOINT BOOT
  1. Separate the rear drive shaft inboard joint boot from the inboard joint assembly.



4. REMOVE REAR DRIVE SHAFT INBOARD JOINT ASSEMBLY
  1. Remove the grease from the inboard joint assembly.



    C108300E02
  1. Put matchmarks on the inboard joint assembly and outboard joint shaft.

    NOTICE:
    Do not use a punch for the marks.

  1. Remove the rear drive shaft inboard joint assembly.

    NOTICE:
    Be careful not to drop the inboard joint assembly.



    C108301E02
  1. Put matchmarks on the outboard joint shaft, inner race and cage.

    NOTICE:
    Do not use a punch for the marks.

  1. Remove the 6 balls.

    NOTICE:
    Be careful not to drop the balls.

  1. Slide the cage to the outboard joint side.



    C108302
  1. Using a snap ring expander, remove the snap ring.

  1. Hold the outboard joint shaft assembly between aluminium plates in a vise.

    NOTICE:
    Do not overtighten the vise.



    C108303
  1. Using a brass bar and hammer, remove the inner race.

  1. Remove the cage.

  1. Remove the No. 2 rear drive shaft inboard joint boot clamp and rear drive shaft inboard joint boot clamp.



5. REMOVE NO. 2 REAR DRIVE SHAFT OUTBOARD JOINT BOOT CLAMP


  1. for One touch type:



      C108304
    1. Using a screwdriver, remove the No. 2 rear drive shaft outboard joint boot clamp as shown in the illustration.



  1. for Claw engagement type:



      C086760E01
    1. Using needle nose pliers, remove the No. 2 rear drive shaft outboard joint boot clamp as shown in the illustration.



6. REMOVE REAR DRIVE SHAFT OUTBOARD JOINT BOOT CLAMP


  1. for One touch type:



      C108306
    1. Using a screwdriver, remove the rear drive shaft outboard joint boot clamp as shown in the illustration.



  1. for Claw engagement type:



      C086759E01
    1. Using needle nose pliers, remove the rear drive shaft outboard joint boot clamp as shown in the illustration.



7. REMOVE OUTBOARD JOINT BOOT
  1. Remove the outboard joint boot from the rear drive shaft outboard joint shaft assembly.

  1. Remove the grease from the outboard joint shaft assembly.