Home › HYBRID SYSTEM ยท Q211 HYBRID TRANSMISSION / TRANSAXLE › HYBRID TRANSAXLE FLUID

HYBRID TRANSAXLE FLUID > REPLACEMENT

for Preparation Click here



1. DRAIN HYBRID TRANSAXLE FLUID


    C170282E01
  1. Using a socket hexagon wrench 10 mm, remove the filler plug and gasket.

  1. Using a socket hexagon wrench 10 mm, remove the drain plug and gasket.

  1. Using a socket hexagon wrench 10 mm, install the drain plug and a new gasket.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }



2. ADD AND INSPECT HYBRID TRANSAXLE FLUID
  1. Add transaxle fluid.



    C170291E02
  1. Check that the fluid surface is within 5 mm (0.20 in.) from the lowest position of the inner surface of the transaxle filler plug opening.

    NOTICE:
    1. Stop the vehicle on a flat road.
    2. Recheck the transaxle fluid level after driving when exchanging oil.
    3. Insufficient or excessive amounts of transaxle fluid may be the cause of some trouble.

  1. Check for leaks if the transaxle fluid level is low.

  1. Using a socket hexagon wrench 10 mm, install the filler plug and a new gasket.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }