Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B2784    Antenna Coil Open / Short

for Preparation Click here


DESCRIPTION

This DTC is output if there is an open or short in the key coil (built into the power switch).

DTC No.
DTC Detection Condition
Trouble Area
B2784
Antenna coil is open/shorted
  1. Wire harness or connector
  2. Certification ECU (Smart key ECU assembly)
  3. Power switch

WIRING DIAGRAM


B151004E05


INSPECTION PROCEDURE

NOTICE:
If the certification ECU (smart key ECU assembly) is replaced, register the key and ECU communication ID (Click here).

1.CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B2784 output does not recur.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - POWER SWITCH)


    B178824E05
  1. Disconnect the certification ECU (smart key ECU assembly) and power switch connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D40-9 (CODE) - D25-10 (CODE)
    Always
    Below 1 Ω
    D40-8 (TXCT) - D25-9 (TXCT)
    Always
    Below 1 Ω
    D40-9 (CODE) - Body ground
    Always
    10 kΩ or higher
    D40-8 (TXCT) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE POWER SWITCH
  1. Replace the power switch (Click here).


NEXT


4.CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B2784 output does not recur.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (Click here)
OK

END (POWER SWITCH IS DEFECTIVE)