POWER WINDOW CONTROL SYSTEM > Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated) |
| 1.INITIALIZE POWER WINDOW CONTROL SYSTEM |
Initialize the power window regulator motor assembly (on the driver side) (Click here).
Check that the power window operates normally by opening and closing the window.
|
| ||||
| OK | ||
| ||
| 2.CHECK WINDOW GLASS SLIDING MOVEMENT (for Driver Side) |
Remove the window regulator.
Install the window glass onto the door glass run.
Check if the door window regulator operates smoothly.
Check that the window glass slides smoothly when sliding it up by hand.
|
| ||||
| OK | ||
| ||