Home › ENGINE › 3MZ-FE ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    U0001    High Speed CAN Communication Circuit

for Preparation Click here


DESCRIPTION

There are two primary control roles for the hybrid vehicle control ECU. One role is engine control, the other role is hybrid system control. In the hybrid vehicle control ECU, there is a section equivalent to the ECM which is responsible for engine control, and a section referred to as the hybrid vehicle control ECU that is responsible for hybrid system control. These two exchange signals using CAN communication.
If there is a problem with this communication, a DTC is set.

DTC No.
DTC Detection Condition
Trouble Area
U0001
  1. Following conditions are met for 2 seconds (1 trip detection logic):
    1. Power switch on (IG)
    2. Battery voltage 10.5 V or more
    3. No intercommunication between engine control ECU and hybrid vehicle control ECU
Hybrid vehicle control ECU

MONITOR STRATEGY


Related DTCs
U0001: Verify communication
Required Sensors/Components (Main)
ECM (included in the hybrid vehicle control ECU)
Required Sensors/Components (Related)
-
Frequency of Operation
Continuous
Duration
0.68 seconds
MIL Operation
Immediate
Sequence of Operation
None

TYPICAL ENABLING CONDITIONS


Monitor runs whenever following DTCs are not present
None
Battery voltage
10.5 V or more (0.5 seconds or more)
Power switch
ON

TYPICAL MALFUNCTION THRESHOLDS


Communication between ECM (included in the hybrid vehicle control ECU)
No communication

INSPECTION PROCEDURE

1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC U0001)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  1. Read the DTCs.

    Result:

    Display (DTC output)
    Proceed to
    U0001
    A
    U0001 and other DTCs
    B



B
GO TO DTC CHART
A

REPLACE HYBRID VEHICLE CONTROL ECU (Click here)