DTC B278A Short to GND in Immobiliser System Power Source Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B278A | Power switch power source circuit is open or shorted |
|

| 1.CHECK DTC OUTPUT |
Delete the DTCs (Click here).
Recheck for DTCs.
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - POWER SWITCH) |
![]() |
Disconnect the certification ECU (smart key ECU assembly) and power switch connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D40-30 (VC5) - D25-14 (VC5) | Always | Below 1 Ω |
| D40-40 (AGND) - D25-8 (AGND) | Always | Below 1 Ω |
| D40-17 (E) - Body ground | Always | Below 1 Ω |
| D40-30 (VC5) - Body ground | Always | 10 kΩ or higher |
| D40-40 (AGND) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (POWER SWITCH POWER SOURCE) |
![]() |
Reconnect the certification ECU (smart key ECU assembly) and power switch connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D40-30 (VC5) - Body ground | Key is not in cabin | Below 1 V |
| D40-30 (VC5) - Body ground | Power switch pressed | 4.6 to 5.4 V |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (POWER SWITCH BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D40-40 (AGND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||