SLIDING ROOF SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK AUTO OPERATION |
Turn the power switch on (IG).
When the roof glass is fully closed, press the OPEN switch for 0.3 seconds or more. Check that the roof glass automatically slides until it is fully opened.
When the roof glass is fully closed, press the UP switch for 0.3 seconds or more. Check that the roof glass automatically tilts until it is fully tilted upward.
When the AUTO operation is operating, check that pressing any personal light switch stops the roof glass operation.
| 2. CHECK SLIDING ROOF OPERATION AFTER POWER SWITCH IS TURNED OFF |
Turn the power switch from on (IG) to off, and check that the sliding roof operates. Then open and close the driver's side door once, and check that the sliding roof does not operate.
Turn the power switch from on (IG) to off and wait for approximately 43 seconds. Check that the sliding roof does not operate.
Operate the AUTO (SLIDE OPEN or TILT UP) operation. While the roof glass is in motion, turn the power switch from on (IG) to off.
| 3. CHECK JAM PROTECTION FUNCTION |
![]() |
When the sliding roof operation is operating and an object is caught between the vehicle body and glass, check that the roof glass opens 218 mm (8.58 in.) from the point of contact with the object, or opens fully if there is not an opening distance of 218 mm (8.58 in.).
![]() |
When the TILT UP/DOWN function is operating, and an object is caught between the vehicle body and the roof glass, check that the sliding roof tilts up fully.