CRUISE CONTROL SYSTEM > TC and CG Terminal Circuit |

| 1.CHECK HARNESS AND CONNECTOR (TERMINAL TC of DLC3 - HYBRID VEHICLE CONTROL ECU) |
![]() |
Disconnect the D35 connector from the hybrid vehicle control ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D35-3 (TC) - D47-13 (TC) | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (TERMINAL CG of DLC3 - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D47-4 (CG) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (TERMINAL TC of DLC3 - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D47-13 (TC) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||