ENGINE IMMOBILISER SYSTEM > ID Code Box Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (ID CODE BOX - BATTERY) |
![]() |
Disconnect the ID code box (immobiliser code ECU) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D31-1 (+B) - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (ID CODE BOX - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D31-8 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||