Home › STEERING › STEERING COLUMN › STEERING COLUMN ASSEMBLY

STEERING COLUMN ASSEMBLY > DISASSEMBLY

for Preparation Click here


NOTICE:
When using a vise, do not overtighten it.



1. REMOVE STEERING LOCK ACTUATOR ASSEMBLY
  1. Secure the steering column assembly in a vise.

  1. Using a center punch, mark the center of the 2 tapered-head bolts.

  1. Using a 3 to 4 mm (0.12 to 0.16 in.) drill, drill a hole in each tapered-head bolt.



    C166127E01
  1. Using a screw extractor, remove the 2 tapered-head bolts, and then remove the steering lock actuator assembly and the steering lock bracket from the steering column assembly.