Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > FAIL-SAFE CHART

for Preparation Click here



FAIL-SAFE FUNCTION
  1. When communication fails in any of the CAN bus wires (communication wires) due to a short circuit or other causes, the fail-safe function, which is specified for each system, operates to prevent the system from malfunctioning.

  2. The following chart shows the relationships between components, system functions, and effects of communication failure on these functions. (For further details, see the pages for each system.)

    Function
    (Function Description)
    Control Master
    System Related
    Fail-safe Operation
    DTC
    (Driver Detectable)
    Toyota Hybrid System-II (THS-II) Control
    (to optimize the combination between the engine and motor drive power for driving)
    Hybrid Vehicle Control ECU
    (HV control)
    HV Control ECU
    (Engine control)
    Safe running
    U0100
    (Master warning light and MIL come on)
    Gradient Determination
    (Hill start assist operation)
    Hybrid Vehicle Control ECU
    (HV control)
    Skid Control ECU
    Hill start assist function stops
    U0129
    (VSC warning light comes on)
    Regenerative braking
    (the motor acts as a generator that depends on wheel rotation and generates electricity to be stored in the HV battery)
    Skid Control ECU
    Hybrid Vehicle Control ECU
    Regenerative braking stops
    U0073, U0293
    (Warning light comes on)
    VDIM control
    (Controls driving force while VDIM in operation)
    Skid Control ECU
    1. ECM
    2. Steering Angle Sensor
    3. Yaw Rate Sensor
    VDIM control is inoperative
    (VDIM control gradually stops)
    U0073, U0100, U0123, U0124, U0126
    (Warning light comes on)
    Electric power steering
    (Speed of vehicle induction type torque control)
    Power Steering ECU
    1. Hybrid Vehicle Control ECU
    2. Skid Control ECU
    Depression of EPS assist
    (Deterioration of steering)
    U0073, U0100, U0129, U0293
    (VSC failure: warning light comes on, and decrease of assistance power at vehicle speed 120 km/h [74 mph])
    (ECM failure : Warning light comes on [only before assist beginning])
    Meter display (Displays operation condition and DTCs)
    Combination Meter
    1. Hybrid Vehicle Control ECU
    2. Skid Control ECU
    3. Center Airbag Sensor Assembly
    4. Certification ECU
    5. Main Body ECU
    6. Power Steering ECU
    Light does not come on, illuminates abnormally, or blinks abnormally
    U0100, U0129
    (Abnormal light illuminates)
    Meter buzzer (Combination meter)
    Combination Meter
    1. Hybrid Vehicle Control ECU
    2. Skid Control ECU
    3. Center Airbag Sensor Assembly
    4. Certification ECU
    5. Main Body ECU
    Meter buzzer does not sound
    U0100, U0129
    Air conditioning control
    Air Conditioning Amplifier
    1. Hybrid Vehicle Control ECU
    2. Combination Meter
    3. Main Body ECU
    Air conditioning function and PTC heater function stop
    B1499
    (Air Conditioning is inoperative)
    Smart entry function / Power door lock control
    Certification ECU
    1. Combination Meter
    2. Main Body ECU
    Unlock permitted
    U0327, U1002
    (Wireless door lock cannot operate)
    Tire pressure warning
    Tire Pressure Warning ECU
    1. Combination Meter
    Warning function stops
    C2179
    (Warning light blinks for 1 minute and then illuminates)