CAN COMMUNICATION SYSTEM > Steering Angle Sensor Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Steering Angle Sensor Communication Stop Mode |
|
|

| 1.CHECK CAN BUS LINE FOR DISCONNECTION (STEERING ANGLE SENSOR BRANCH WIRE) |
Turn the power switch off.
Disconnect the steering angle sensor connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D14-3 (CANH) - D14-2 (CANL) | Power switch off | 54 to 69 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (IG, ESS) |
Disconnect the steering angle sensor connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D14-1 (ESS) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D14-4 (IG) - Body ground | Power switch on (IG) | 10 to 14 V |
|
| ||||
| OK | ||
| ||