Home › ENGINE › 3MZ-FE FUEL › FUEL INJECTOR

FUEL INJECTOR > INSPECTION

for Preparation Click here



1. FUEL INJECTOR ASSEMBLY


  1. Inspect injector resistance.



      A175795E01
    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      TCV - +B
      20°C (68°F)
      13.4 to 14.2 Ω

      If the resistance is not as specified, replace the injector.



  1. Inspect the injection volume.

    CAUTION:
    This test involves high-pressure fuel and electricity. Take all precautions regarding safe handling of both the fuel and the electricity. Perform this test in a safe area, and avoid any sparks or flames. Do not smoke.




      A088228E02
    1. Connect the fuel tube connector to SST (hose), then connect the tube connector to the fuel pipe (the vehicle side).

      SST
      09268-31012   (09268-41500, 90467-13001, 95336-08070)

    2. Install a new O-ring to the fuel injector.



    3. A175796E01
    4. Connect SST (adaptor and hose) to the injector, and hold the injector and adapter with SST (clamp).

      SST
      09268-31012   (90467-13001, 95336-08070, 09268-41110, 09268-41300)



    5. A175797E01
    6. Put the injector into a graduated cylinder.

      CAUTION:
      Install a strong rubber tube onto the injector to prevent gasoline from splashing.

    7. Operate the fuel pump (turn the power switch on (IG)).

    8. Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.

      SST
      09842-30070  

      Injection volume:
      Tester Connection
      Condition
      Specified Condition
      Positive terminal - Ground terminal
      Per 15 seconds
      60 to 73 cm3 (3.7 to 4.5 cu in.)

      Difference between each injector:
      11 cm3 (0.7 cu in.) or less

      NOTICE:
      Always do the switching at the battery side.

      If the injection volume is not as specified, replace the injector assembly.



  1. Inspect the leakage.



      B000069
    1. In the condition above, disconnect the tester probes of SST (wire) from the battery and check the fuel leakage from the injector.

      Fuel drop:
      1 drop or less in 12 minutes