TIRE AND WHEEL SYSTEM > INSPECTION |
| 1. INSPECT TIRE |
Check the tires for wear and proper inflation pressure.
| Tire size | Front kPa (kgf/cm2, psi) | Rear kPa (kgf/cm2, psi) |
| P245/55R19 103S P245/65R17 105S | 230 (2.3, 33) | 230 (2.3, 33) |
| 230 (2.3, 33) | 230 (2.3, 33) |
![]() |
Using a dial indicator, check the runout of the tires.
| 2. ROTATE TIRES |
![]() |
Rotate the tires as shown in the illustration (A). If the vehicle is equipped with a grand spare tire, rotate the tires as shown in the illustration (B).
| 3. INSPECT WHEEL BALANCE |
Check and adjust the off-the-car balance.

| 4. INSPECT FRONT AXLE HUB BEARING LOOSENESS |
| 5. INSPECT REAR AXLE HUB BEARING LOOSENESS |
| 6. INSPECT FRONT AXLE HUB RUNOUT |
| 7. INSPECT REAR AXLE HUB RUNOUT |